TSB's

Mitsubishi shock install changed

This TSB applies to 2010 and 2011 Mitsubishi Outlander vehicles produced since July 2010. The right side shock absorber installation procedure has been changed.

The manual currently lists shock absorber assembly/installation as follows:

“Install the shock absorber assembly so that the coil spring end faces the rear of the vehicle.”

The updated change is as follows: “Install the shock absorber assembly (LH) so that the coil spring end faces the rear of the vehicle.  Install the shock absorber assembly (RH) so that the coil spring end faces the front of the vehicle.”

The bottom of the coil spring end must face the rear of the vehicle on the left-hand side of the vehicle; and the spring end must face the front of the vehicle on the left-hand side.
<p>The bottom of the coil spring end must face the rear of the vehicle on  the left-hand side of the vehicle; and the spring end must face the  front of the vehicle on the left-hand side.</p>

Post a comment
 

Comments (0)

 

Post a Comment

Submit
Subscribe Today

Subscribe to Auto Service Professional

Sign up for a FREE subscription to Auto Service Professional magazine

Subscribe