Nucap Industries Inc. says its Brake Align runout correction plates provide the simplest, least costly and most effective solution to correcting excessive lateral runout. Brake Align corrects for lateral runout generated by the stacked tolerances between the hub assembly and brake rotor flange.
Brake Align measures lateral runout with a dial indicator and runout can be corrected in less than five minutes per wheel. With two taper sizes available, Brake Align allows for runout up to .009-inch over specification to be corrected without the need for a costly wheel hub bearing replacement or the use of an on-the-car brake lathe.
Using Brake Align does not involve cutting a new rotor which can affect the integrity of the rotor and surface condition.
For more information visit http://www.nucap.com/products/solutions/brake-align.