TSB's

Rear monitor re-initialization

This bulletin applies to 2011 Toyota Sienna models equipped with a rear view monitor system. Any time the battery terminal has been disconnected, the rear view monitor system must be re-initialized.

1. Start the engine and check if the rear view monitor system is operative.

2. Shift the shift lever to the R position. If the rear view monitor appears as illustrated in Figure 1, you must re-initialize the rear view monitor system.

3. Shift the shift lever to the P position. Turn the steering wheel lock to lock.

4. Shift the shift lever to the R position and touch the parallel parking mode switch on the screen. When the longitudinal guidelines and “Check surroundings for safety” appear on the rear view monitor as shown in Figure 2, the initialization of the parking assist monitor has been completed.

Figure 1: If no guidelines appear on the rear view monitor, the system must be re-initialized.
<p>Figure 1: If no guidelines appear on the rear view monitor, the system must be re-initialized.</p>

Figure 2: After placing the transmission in P and turning the steering wheel lock to lock; and then shifting to R, touch the parallel parking mode switch on the screen. Guidelines and the message “Check surroundings for safety” should appear.
<p>Figure 2: After placing the transmission in P and turning the steering wheel lock to lock; and then shifting to R, touch the parallel parking mode switch on the screen. Guidelines and the message &ldquo;Check surroundings for safety&rdquo; should appear.</p>

Tags: Toyota 
Post a comment
 

Comments (0)

 

Post a Comment

Submit
Subscribe Today

Subscribe to Auto Service Professional

Sign up for a FREE subscription to Auto Service Professional magazine

Subscribe