Sponsored by
Penray Introduces Plastic-Friendly MAF Sensor Cleaner


Use of Penray's MAF sensor cleaner lets the sensor perform is job properly, the company notes.
<p>Use of Penray's MAF sensor cleaner lets the sensor perform is job properly, the company notes.</p>

Penray Inc. has introduced its new cleaner for mass air flow (MAF) sensors, part number 2520, which is plastic-friendly.

The attachment point for the MAF sensor is usually a small plastic clip. Often aggressive solvents, like typical carburetor cleaners, can damage delicate plastic pieces, says Penray. The new Penray 2520 is specially formulated to effectively clean the sensitive component without harming plastics, coatings or adhesives.

Use of Penray's MAF sensor cleaner is easy.  The sensor element is typically accessed by unsnapping a few retaining clamps and lifting off a piece of plastic ductwork to reveal the fine sensor wire. This wire is very fragile; physically touching it is not possible without likely damage. Once the sensor is removed from the duct, several sprays of Penray 2520 will quickly dissolve deposits, so the full length of the wire is once again free of contamination. Newly exposed to the rush of incoming air, the sensor is able to perform its job properly and accurately.

According to Penray’s Mark Kardon, director of marketing, "Poor engine performance or degraded fuel economy can often be traced to a contaminated MAF sensor fine wire, especially when it reaches the point where it causes a Check Engine light to illuminate. Adding the use of this simple-to-use product to routine maintenance restores the performance of the wire and sensor, preventing the huge expense of a new sensor assembly."

More iInformation on Penray’s products can be found at www.penray.com.

Post a comment

Comments (0)


Post a Comment

Subscribe Today

Subscribe to Auto Service Professional

Sign up for a FREE subscription to Auto Service Professional magazine