Displaying 1 - 10 of 42

TOPIC : Hyundai

SPONSORED BY

Hyundai Rattle

Some 2011 Hyundai Sonata vehicles equipped with a 2.4L engine may exhibit a rattle sound from the driver’s side of the engine compartment. This can be observed during certain engine operating speed ranges from 1,600-2,000 rpm or during light acceleration.

SPONSORED BY

Hyundai Lower Joint Change

This bulletin applies to 2011 Hyundai Santa Fe vehicles. Effective with production date 10-24-2007, the front lower arm ball joint design has been changed.

SPONSORED BY

Hyundai Neutral Start Adjustment

This bulletin applies to 2009 and later Hyundai Genesis models equipped with a 3.8L V6 engine. An improperly adjusted neutral start switch (inhibitor switch) may result in a no-start condition in neutral or park, along with DTCs P0707 (transmission range sensor circuit low input) or P0708 (transmission range sensor circuit high input).

SPONSORED BY

Want cheese with that whine?

This bulletin applies to all Hyundai vehicles. Before replacing a power steering pump for a whine noise condition, check the pump reservoir filter screen for contamination.

0

Leaky oil sensor

This bulletin applies to Hyundai Santa Fe and Sonata vehicles equipped with a 3.3L engine. Look for an oil leak at the oil temperature sensor. Verify that the leak is at the sensor’s threaded area. Use of florescent dye can be used to isolate the leak.

0

Shifty Hyundai

This bulletin applies to certain Hyundai vehicles where one or more of the following automatic transaxle DTCs are stored:

0

Hyundai Tucson: Mistakes happen

2005-2008 Hyundai Tucson 2.0L and 2.7L engines are equipped with different air filter housings. If the incorrect air filter housing is installed, DTC P0171/P0174 (system too lean) may result.

0

Hyundai cold reverse rattle

Some 2011-2012 Hyundai Elantra vehicles (equipped with automatic transmission) may experience a rattle noise from the front of the vehicle with the brake applied, in reverse gear, after a cold start. The noise does not occur after engine warm-up. Do not replace the transmission for this condition. Follow the repair procedure and replace the front muffler.

0

Hyundai transaxle DTCs

This TSB applies to Hyundai vehicles equipped with an automatic transaxle where DTCs P0715, P0716, P0717, P0720, P0721 and P0722 are present.

0

Hyundai wants on-car lathe

When brake disc machining is required, Hyundai recommends the use of an on-car brake lathe, PFM 9.0 or higher version made by PRO-CUT. The SPX part number is 38-PFM90.5 for PFM 9.0 brake lathe with five adapters. The tool is also available through the Hyundai Dealer Equipment Program at (866) 539-4248.

Subscribe Today

Subscribe to Auto Service Professional

Sign up for a FREE subscription to Auto Service Professional magazine

Subscribe