Technical Service Bulletins

Stop the Vibration in Toyota Tacoma

Order Reprints
TOY01 Tacoma TSB.jpg

The red arrows indicate the axle flange boss.

| All Photo Credits: Mitchell 1

Some 2017-2019 Toyota Tacoma trucks equipped with the BD20 differential (non-TRD) may exhibit a noise or vibration from the rear at low speeds or while braking. This may be caused by excessive clearance between the brake drum and axle drum flange.

TOY02 Tacoma TSB.pngSide view showing where to measure flange boss diameter.

 

Inspect the rear axle flange for corrosion/rust buildup. If present, use a wire brush to clean. Measure the diameter of the axle flange boss using a dial or digital caliper. Take measurements in at least three clock positions. The specification is 4.252 – 4.250 inches (108.000 – 107.946 mm). If out of spec, replace the axle.

TOY03 Tacoma TSB.jpgUse a caliper to measure flange boss diameter, in at least three locations to verify an accurate measurement.

 

Related Articles

Toyota Tacoma Rear Brakes Need Attention

Don't Forget the Plug in Toyota

You must login or register in order to post a comment.