News Technical Service Bulletins

Verify Adaptive Learning Procedures on Ford Explorer

Order Reprints
FORD (2).jpg

This bulletin applies to 2011-2019 Ford Explorer vehicles. DTCs U2100 and U2101 indicate that the module has not been properly configured.

| Photo Credit: Ford

This bulletin applies to 2011-2019 Ford Explorer vehicles. DTCs U2100 and U2101 indicate that the module has not been properly configured.

Check the repair history for any module replacement and verify all adaptive learning procedures were performed. Go to IDS>Toolbox>Module>Programming>As-Built>Select module.

 When asked, “Were you sent here to obtain part numbers from another procedure”, answer “No” to configure the module.

Related Articles

Ford Explorer Needs Module Configured

ASE to Offer Webinar on Using Audi OEM Procedures Through erWin

Ford Explorer CAT Sensor

You must login or register in order to post a comment.