Technical Service Bulletins

Special Ring Gear Service

Order Reprints
Special Ring Gear Service

Replacing the rear axle ring and pinion on the corporate 8 ¼-inch axle with a 3.21:1 gear ratio as found on 2007-2008 Dodge Nitro models requires a specific and unique service procedure.

Follow procedures available in DealerCONNECT > TechCONNECT under Service > 3 – Differential & Driveline > Rear Axle – 8 ¼ > Gear-Pinion/Ring > Removal And Installation > Gear-Pinion/Ring.

  a. Removal of the ring gear from the differential requires pressing the ring gear off of the differential with Plug 8926-2 and Remover 10126-1.

  b. Installation of the ring gear onto the differential requires the use of a bearing heater and left-hand threaded pins P/N 10126-2.

These special service tools are required for the 8 ¼-inch ring gear in addition to standard rear axle service tools.

Related Articles

Jeep rear end service procedures

Stop & Start Needs Special Battery

Special tool for BMW

You must login or register in order to post a comment.