Sporadic Audi DTC
When experiencing sporadic fault memory entries on 2000-2010 Audi vehicles, Audi suggests inspecting/correcting connections.
Contacts may be widened (over 0.63mm) by using incorrect pins or incorrect methods for current flow tests. Either action may cause intermittent electrical connections. This may cause sporadic DTCs to be stored in various control modules.
Check the contacts on the control module and connector. Verify that all pins and terminals are securely clipped into the connectors. Verify that no pins are bent or deformed. Verify proper crimping as described and illustrated in Figure 1.
Mechanically check the contacts on the control module and connector. Test the individual terminals by using the standard 0.63mm male pin (see Figure 1 and Parts Table) to verify proper contact. Make sure that the test pin is not twisted and is inserted correctly into the female terminal. The contact must be tight, but it must still allow the pin to slide into the terminal of the control module connector. Only use the 0.63mm male pins, because the female terminals are designed for these pins, which are the only terminals found in the connectors for the control modules.
If the pin/terminal is deformed, improperly crimped or does not contact properly, the contact must be replaced with the VAS 1978A repair kit or ordered in sets.
Part number Part description Qty
000 979 007 Male pin 1*
000 979 012 Male pin 1*
000 979 409 Male pin 1**
*An order of 1 will provide a bag of 5 wires with like connectors on each end.
** An order of 1 will provide a bag of 3 wires with like connectors on each end.