TSBs

VW Cam Signal

Order Reprints
VW Cam Signal

This bulletin applies to 2016-2017 Volkswagen Tiguan vehicles equipped with a 2.0L engine. If DTC P0011 (camshaft position Bank 1 timing over-advanced or system performance) or P0016 (crankshaft position-camshaft position correlation bank 1 sensor A) is found, and the engine runs rough at idle, inspect the condition of the camshaft bearing bridge. Wear can cause axial movement of the camshaft.

Remove the camshaft bearing bridge according to the repair manual. Check the camshaft side of the bearing bridge for damage (groove in bearing surface or lip protruding from the bearing surface). If damaged, replace the bearing bridge. Be sure to change the engine oil and filter after repairs.

P/N ............................ PART

06H 103 144................Bearing bridge

N 910 967 01...............Bolt

WHT 007 212...............O-ring

06J 115 403Q...............Oil filter 

Related Articles

Chevrolet Says Vehicle May Have Wrong Cam

Toyota Remote Connect App May Not Operate

You must login or register in order to post a comment.