TSBs

Highlander HV DTC

Order Reprints
Highlander HV DTC

Some 2011-2012 Toyota Highlander HV vehicles may exhibit a MIL on with DTC P314A, information code 828 (inverter coolant pump speed signal) stored in the power management control ECU (HV ECU).

This bulletin applies to vehicles produced before the production change effective VIN JTEDC3EH#C2007148.

  1. Using TIS Techstream, confirm that DTC P314A, information code 828 is present.
  2. If this DTC is present, check the INV W/P fuse for loose fitting in the engine room relay block No. 2. If the fuse is loose, proceed to Step 3. If not, this bulletin does not apply.
  3. Replace the engine room relay block No. 2. Be sure to disconnect the 12V auxiliary battery prior to removing the pins from the engine room relay block No. 2.
  4. Clear all DTCs and test drive to verify the repair.

PARTS INFORMATION

Block, engine room relay No.2…………..82742-48020

TOOLS REQUIRED

TIS Techstream…………………………….TSPKG1 or TSLITEDLR01

(software version 7.10.030 or later required)

Wire harness repair kit B………………...00002-04210-01

Double locking pick tool…………………..00002-217958

Related Articles

Highlander Stop & Start System Needs Specific Battery

Toyota Remote Connect App May Not Operate

Toyota Issues a Recall Due to Fuel Pump

You must login or register in order to post a comment.