Technical Service Bulletins Parts

Unwanted Braking

Order Reprints
Unwanted Braking

 This bulletin applies to 2012-2014 Cadillac Escalade models. Some owners may comment on unwanted grade braking when not driving down a grade, reduced/low engine power with no DIC messages or DTCs present, and/or busy or frequent transmission up and down shifts with no DTCs.

These issues may be caused by the BPP (brake pedal position) sensor not being learned correctly in the ECM.

To view the BPP data in the ECM, use the Tech 2 scan tool as follows: Powertrain/Select Engine Type/Engine Control Module/data Display/Auto. Transmission data GDS (2014 models: Module Diagnostics/Engine Control Module/Data Display/Automatic Transmission Data).

Scroll down and view the following parameter:

BPP Signal = Applied or Released (should read Released with brake pedal released).

BPP Sensor = 0% to 100% (should read 0% with brake pedal released).

BPP Sensor = Varying voltage (should read near 1 volt with pedal released).

BPP Sensor Learned Released Position = Voltage (should equal the BPP sensor voltage with pedal released).

With the brake pedal released, use the BPP sensor parameters to determine if the ECM has learned the BPP released position correctly. If the BPP Sensor learned Released Position voltage does not match the BPP sensor voltage with the pedal in the released position, the ECM will need to have a BPP relearn performed.

If the ECM will not perform a BPP sensor relearn, then SPS program the ECM. After the ECM SPS programming is complete, the BPP will relearn. Use the Tech 2 to verify that the BPP sensor is now showing 0% with the brake pedal released.

Related Articles

Mazda click/pop during braking

Jaguar Might Pause Braking

Caddy Connector

You must login or register in order to post a comment.