TSBs

Honda mystery with engine off

Order Reprints
Honda mystery with engine off

This bulletin applies to all 2013 Honda models equipped with one-push start. When you shift into Park and shut off the engine, does the power mode stay in ON or ASCCESSORY? The culprit could be a misadjusted shift cable.

If it’s not adjusted correctly, it puts pressure on the shift lever, keeping the park pin switch from opening. The power control unit needs the park pin switch position input to switch the power mode to vehicle off (lock).

To find and repair this problem, connect the HDS and go to the ONE-PUSH START/PCU Data List. Scroll down to AT SHIFT POSITION P and AT SHIFT POSITION P-PIN.

Shift into Park while keeping your foot on the brake pedal. Them without pressing the release button, pull back on the shift lever (toward Reverse). The AT SHIFT POSITION P signal should read ON and the AT SHIFT POSITION P-PIN signal should read OFF.

Another test is to shift into Reverse while depressing the brake pedal. Then, press the release button and gently push the shift lever into Park. When it goes into Park, the AT SHIFT POSITION P signal should then read ON and the AT SHIFT POSITION P-PIN signal should read OFF.

If you don’t get the expected results from either of these tests, refer to the electronic service manual and adjust the shift cable.

Related Articles

Subaru Has an RPM Drop With A/C Off

Audi Engine Idle Speed May be Too High

Honda Recalls Odyssey Vehicles Due to Possible Pinch

You must login or register in order to post a comment.