Technical Service Bulletins

Ticking Explorer

Order Reprints
Ticking Explorer

Some 2011-2013 Ford Explorer vehicles may exhibit a noise form the front wheel area when accelerating from a stop or when shifting between drive and reverse. The noise is usually described as a ting or a pop type noise.

  1. Separate the halfshaft from the wheel hub. Refer to the workshop manual, section 205-04. Do not remove halfshafts from the transmission or power transfer unit (PTO).
  2. Install one thrust washer, metal surface first, over the halfshaft splines until the metal ring is flat against the wheel bearing mating surface. The nylon surface should face outward toward the hub/splines.
  3. Assemble the halfshaft to the wheel hub. A new ball joint nut and wheel hub nut must be used during assembly.

PART                              P/N

Washer, thrust………..BB5Z-7G273-A

Nut, wheel hub……….W712435-S439

Nut, ball joint…………W714890-S440

Related Articles

Ticking GM V8 lifters and DTC

Toyota prop shaft ticking

Ticking cylinder head

You must login or register in order to post a comment.