Technical Service Bulletins

Nissan power steering hose change

Order Reprints
Nissan power steering hose change

Do not replace other related hoses unless necessary (do not replace as a set). Do not damage the pressure sensor during removal or installation. Always use a new O-ring when installing a new or existing pressure sensor. Pressure sensor mounting torque is 14.5 ft.-lbs. Always replace both copper washers (mounted at the power steering pump).

Do not allow dirt or contamination to enter the hydraulic system. Always secure the pressure sensor mounting block in a soft jaw vise when removing or installing. Do not clamp onto the banjo end of the hose.

PARTS INFORMATION

DESCRIPTION                       HOSE W/SENSOR        HOSE W/O SENSOR     QTY

Hose & tube assembly……….49720-7S000                  49720-7S00A                  1

Copper washer……………….49726-Y0100                                                               2

O-ring seal……………………49345-6N200                                                               1

Pressure sensor……………….49763-6N20A                                                           1

Related Articles

Power steering hose change

Cold Zaps GM Power Steering

Ram Steering Change

You must login or register in order to post a comment.