TSBs

Hybrid MIL for 02 sensor

Order Reprints
Hybrid MIL for 02 sensor

Some 2008-2009 Toyota Camry HV vehicles may exhibit a MIL-on with P2238 (oxygen sensor pumping current circuit low /Bank 1, Sensor 1) or P2237 (oxygen sensor pumping circuit open / Bank 1, Sensor 1).

An improved engine wiring harness has been developed to address this condition.

This TSB applies to vehicles built before the effective production change as follows:

MODEL              PLANT                  PRODUCTION CHANGE EFFECTIVE VIN

CAMRY              TMMK                    4T1BB46K#9U080445

                            Tsutsumi             JTNBB46K#93050540

PARTS INFORMATION

Previous p/n                Current P/N                     Part

82121-33B51                same                                wire, engine

82121-06B70                same                                wire, engine

17177-0H010                same                                gasket, int. manifold to head, No. 1

REQUIRED TOOLS

TIS Techstream P/N TSPKG1 (software version 3.01.000 or later required)

Safety gloves   00002-03100-S (small)

                        00002-03200-M (medium)

                        00002-03300-L (large)

REPAIR PROCEDURE

  1. Using TIS Techstream, check for stored DTCs.
  2. Verify DTC(s) P2238 and/or P2237 are present. If other A/F sensor DTCs are present along with the afore-mentioned DTCs, this TSB does not apply. Follow repair manual procedures to diagnose.
  3. Follow repair manual procedures to inspect the A/F sensor heater and engine rool junction block (A/F relay). Refer to the TIS, applicable model year Camry HV repair manual.

-          2008/2009 Camry HV. Engine/Hybrid System – Engine Control – 2AZ-FXE Engine Control System: SFI System: P2237; Oxygen (A/F) Sensor Pumping Current Circuit / Open (Bank 1 Sensor 1).

  1. If the A/F sensor heater and engine room junction block (A/F relay) are within repair manual specifications, replace the engine wire harness. It is necessary to remove the intake manifold and inverter assembly to access the engine wire harness.

-          For inverter assembly removal: 2008/2009 Camry HV, Engine/Hybrid System – Hybrid/battery Control System – P311 Hybrid Vehicle Control: Inverter with Converter: Removal.

-          For intake manifold removal: 2008/2009 Camry HV, Engine/Hybrid System – Engine Mechanical – 2AZ-FXE Engine Mechanical: Engine Assembly: Removal.

-          For inverter assembly installation: 2008/2009 Camry HV, Engine/Hybrid System – Hybrid/Battery Control System – P311 Hybrid Vehicle Control: Inverter with Converter: Installation.

-          For intake manifold installation: 2008/2009 Camry HV, Engine/Hybrid System – Engine Mechanical – 2AZ-FXE Engine Mechanical: Engine Assembly: Installation.

  1. After engine wire harness replacement, clear DTCs and verify that no DTCs reset. Then warm the engine to operating temperature and test drive to verify the repair. 

Related Articles

Benz Has High Voltage Warning

Toyota Recalls RAV4 Vehicles Due to Water Issue

Audi Engine Idle Speed May be Too High

You must login or register in order to post a comment.