PREV 1 2 3 4 5 6 7 8 NEXT
Displaying 21 - 30 of 163

TOPIC : Dodge

SPONSORED BY

Dodge Dart No-No

This bulletin applies to 2012-2016 Dodge Darts equipped with a 2.4L engine and electric power steering. During EPS module electrical diagnosis and verification, DO NOT disconnect the gray EPS torque sensor connector on the EPS module.

SPONSORED BY

Lazy Thermometer Reflash

This bulletin applies to 2012-2013 Dodge Charger vehicles built between Jan. 12, 2012, and April 27, 2013, and equipped with Outside Temperature Display and/or Vehicle Information Center. The customer may experience a delay to update the ambient air temperature display with the actual ambient air temperature.

SPONSORED BY

Yet Another Ram Reflash

This bulletin applies to 2011 Dodge Ram trucks equipped with an electronic vehicle information center (EVIC) /or Parksense rear park assist. Customers may not understand the EVIC message display “Blinded.” This indicates that the Parksense rear park assist sensors require cleaning. The EVIC flash will change the display to indicate “Clean Sensors.”

SPONSORED BY

Gooseneck Concern

Some Mopar Gooseneck Ball Kits installed to Dodge trucks may have retention balls that do not fully seat into the receiver plate and lock into position. When this occurs, the operator can move the shuttle to the locked position, removing tension on the pin, indicating the gooseneck ball is locked in place when it is not.

SPONSORED BY

Inactive Grille Shutter

This bulletin applies to 2013-2015 Dodge Dart vehicles equipped with Active Grille Shutters (AGS). The bulletin involves confirming that the AGS electrical harness connector is properly connected.

SPONSORED BY

Ram ProMaster MIL

This bulletin applies to 2014 Ram ProMaster 1500 vehicles equipped with a 3.6L engine and built on or before Sept. 12, 2013. A MIL may be on, with DTC P0606 (internal control processor) stored in the PCM.

SPONSORED BY

Ram Relearn

This bulletin applies to 2013-2014 Dodge Ram 1500 trucks equipped with a 5.7L engine, and built on or before May 10, 2014. A false message “Battery Voltage Low – Start Engine to Change Ride Height” may appear in the EVIC (electronic vehicle information center) when unlocking or locking the doors.

SPONSORED BY

Idler Pulley and Belt Re-Route

This bulletin applies to 2007-2008 Dodge Nitro models equipped with a 4.9L engine. Some customers may complain about a tapping noise from the engine compartment after engine warm-up. The remedy involves the installation of a serpentine drive belt and a new design idler pulley using a revised belt routing.

SPONSORED BY

Reflash the Ram

This bulletin applies to a range of Dodge Ram 4x4 trucks equipped with an electronic transfer case and built before Jan. 6, 2012, where the “Service 4WD” light is illuminated and the DTCM requires reprogramming.

SPONSORED BY

Shaky Mirror

This bulletin applies to 2012 Dodge Ram trucks, including 1500, 2500, 3500 and 4500/5500 series, where the left side door tow mirror features a shaking motion in the mirror glass. The cause may be a fault in the pivoting arm between the mirror head and the door mount.

PREV 1 2 3 4 5 6 7 8 NEXT
Subscribe Today

Subscribe to Auto Service Professional

Sign up for a FREE subscription to Auto Service Professional magazine

Subscribe