This bulletin applies to all Nissan vehicles equipped with an Electric Throttle Chamber (for example, 2014 Frontier). If a customer describes a lack of power or poor acceleration, perform the following checks before attempting any repairs:
This bulletin applies to 2013-2015 Nissan Leaf, 2013 Juke, 201302015 Sentra and 2013-2015 NV200 vehicles. You may find a noise (clunking, popping or bumping) when the steering wheel is turned. The noise is coming from the top of either front strut assembly.
This bulletin applies to 2015 and later Nissan vehicles (except Titan trucks equipped with a Cummins V8 diesel engine). The MIL may be on, with DTC P0603 (ECM back up/circuit) stored. This is often the result of low battery voltage or battery terminal disconnections.
Nissan has recalled certain 2015-2017 Murano, 2016-2017 Maxima, 2017-2018 Pathfinder and 2017 Infiniti QX60 vehicles.
This bulletin applies to 2017-2018 Nissan Altima and 2017-2019 Sentra, Versa Note, Rogue, Murano, Armada, Frontier, Titan and NV models. Diagnosis for DTCs P0171 (fuel system lean B1) and P0174 (fuel system lean B2) have been revised.
This bulletin applies to 2013-2015 Nissan Leaf vehicles. If you confirm that there is a noise (clunking, popping or bumping) when the steering wheel is turned, and the noise is coming from the top of either front strut assembly, install a spacer between the upper strut bearing and coil spring at both left and right front strut locations.
This bulletin applies to 2018 Nissan Pathfinder, 2016 Maxima and Murano, 2017 Infiniti QX60, Nissan Maxima, Murano and Pathfinder vehicles.
This bulletin applies to 2015 and later Nissan vehicles. The MIL may be on, with DTC P0603 stored (ECM backup/circuit).
Nissan North America is recalling certain 2017-2018 Pathfinder vehicles. The anti-lock brake actuator pump may allow brake fluid to leak onto an internal circuit board, which may result in an electrical short, increasing the risk of a fire.
This bulletin applies to 2012-2017 Nissan Titan trucks. When diagnosing for DTC C1130 (engine signal), ECM related DTC P-codes must be diagnosed, repaired and DTCs erased first before proceeding with C1130.
Sign up for a FREE subscription to Auto Service Professional magazineSubscribe